Shelving System

Keywords:

Product News

Cantilever rack

悬臂可以是单面或双面，悬臂式货架具有结构稳定，载重能力好、空间利用率高等特点。适用于存放长物料、环型物料、板材、管材及不规则货物。悬臂式货架多用于机械制造行业和建材超市等。加了搁板后，特别适合空间小，高度低的库房，管理方便，视野宽阔，利用率比普通货架更高。悬臂式货架是在传统式货架支柱上装设外悬臂而成，是一种长形物专用的货架。

Keywords:

Shelving System

Through-type racking

Through-type racking, also known as drive-in racking or through-aisle racking, employs a pallet-based storage and retrieval system and is ideally suited for storing goods with a limited product variety but large batch sizes. With the exception of the bays closest to the aisle—where forklifts must enter the rack to retrieve or store items—the recommended maximum depth for single-sided access is generally no more than seven pallet positions. To enhance forklift throughput, guide rails can be installed as needed. Compared with selective racking, through-type (drive-in) racking can increase warehouse space utilization by more than 30%, making it widely used in cold-storage facilities as well as in the food and tobacco industries.

Keywords:

Shelving System

Push-back racking

Push-back racking also evolved from pallet racking and is alternatively referred to as push-back or push-in racking. It operates on the principle of combining rails with pallet carts; the rails are set at a slight incline of about 3°. Leveraging the weight of the goods, pallets are loaded at one end only and follow a first-in, last-out flow. This system is well suited for storing large quantities of a limited product variety, offering high space utilization and flexible, convenient access. The overall depth of the rack should not be excessive—typically no more than six pallet depths—since excessive depth can lead to significant space loss due to the interlocking of the pallet carts. The weight of each pallet load is generally capped at 1,500 kg, and the rack height is usually kept below 6 meters.

Keywords:

Shelving System

Flow rack

Flow rack systems feature flow rails installed at a specific angle across the rack, allowing goods stored in material bins to slide downward under gravity, thereby enabling one-way flow and conveyance. The rack consists of upright posts, front and rear stop beams, support beams, limit plates, flow rails (either aluminum alloy or sheet-metal type), flow-rail fasteners, deceleration plates, and other components. Both the rack height and the slope are adjustable. Due to their first-in-first-out operation, these systems are primarily suited for distribution centers (DCs) with picking requirements and for intra-workstation material transfer within factory workshops.

Keywords:

Shelving System